Support for jewelry to personalize - long drop 10x39x3mm - model and finish of your choice

ATTENTION :
Due to the various crises, current events...we are no longer able to produce stock in advance.
We give you the possibility in the event of a stock shortage to place an order, the parts will be made to order, with lead times +/- varying depending on the work in the workshop. It is very difficult to give deadlines. We leave for approximately 6/8 weeks minimum.
From January we produce stocks for June, and from June for the end of the year.. from September we are not able to give deadlines.

---

Tinplate support handcrafted in our workshop near Montpellier in the south of France, in small series, sanded one part one by hand.

All our products meet current French standards (lead, nickel, cadmium free, etc.)

No ring model for this collection.

- silver 8/10 microns,
- brass,
- 1 micron 24 carat gold
- Raw tin without treatment or finishing.

---
For each model we make a mold, before melting the tinplate, which will then be sanded, polished and covered with a layer of silver, brass, gold for the finish...

----
3mm deep
10x39mm

We advise you to clean the supports with jewelry chamois (removes fingerprints, oxidation, etc.)

All our supports are guaranteed for 1 year (welding, silvering, etc.) and meet French standards.
Our products are subject to increases in the price of raw materials.

For the glue, use a jewelry glue such as Hasulith, without forgetting to roughen the bottom of the bowl for better adhesion (with sandpaper, Dremel, etc.)

Do not hesitate to contact us for any additional information regarding our products.